Section 16.5
Igniter Module

The igniter module creates a ground path for the ignition coil primary circuit and limits the current to 7.5 amps. A 12-volt power source is supplied to the igniter module along with the command signals from the ECM.‪

Section 16.5.1
Removal of Igniter Module

Remove the igniter module as follows:‪

1. Disconnect the ignitor coil harness from the igniter module.
2. Unscrew the two M6 x 1.0 attachment bolts.
3. Inspect the igniter. Refer to "16.5.1.1 Inspection of Igniter Module" .

Section 16.5.1.1
Inspection of Igniter Module

Inspect the igniter module as follows:‪

1. Visually check the back surface of the igniter module, igniter module bracket, and connectors for dirt and debris.

   EYE INJURY ‪
   To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure.‪

   1. If dirt and debris are present, clean as necessary with compressed air and reuse. Refer to "16.5.2 Installation of Igniter Module" .
   2. If no dirt or debris are present, reuse the igniter module. Refer to "16.5.2 Installation of Igniter Module" .

Section 16.5.2
Installation of Igniter Module

Install the igniter module as follows:‪

1. Install the two M6 x 1.0 mounting screws. Torque to 13 - 16 N·m (10-12 lb·ft).
2. Press the connectors into the igniter module.